undefined

Split taper bushing P1 1”

The Stainless Steel AVW - Z - Dual Wrap w/Dual Mini Mitter Combo and the best Mini Mitter combined in one unit ideal for space savings in tunnels and clean appearance desired in longer tunnels. Z-Wrap Around operate gravity. No complicated controls, because of the Design it can self adjust to most conveyor speed requirements. Simple design is constructed of heavy grade Stainless steel. Van High brush height is ideal for vans and sport utility vehicles because it cleans the sides with smooth even pressure.The AVW Contour is constructed of heavy grade Stainless steel designed to rotate reverse of the AVW Wrap Around and to provide constant pressure to the side of vehicles. Compact cleaning (12’) Retract kit is available In order to get a higher application pressure at either driver side or passenger side of the machine, move the bottom bearings towards the its center, or away from the center to achieve lower application pressure. In order to get a higher application pressure at either driver side or passenger side of the machine, move the bottom bearings towards the its center, or away from the center to achieve lower application pressure. Brush climb up on back ends of the car Possible Causes & Troubleshooting: • The car is rolling ahead because of uneven floor and stopping with wrap on rear of car. • Torque (Pressure) is set too high and brush will not stall as it climbs. • Brush speed may be too fast. set at 60 RPM • Brush may be set to travel more than 3/4 of backend of car / more swing after break- in period. • Keep pivot point low as possible try not to mount over tire brushes or where high clearance is needed off the floor. • Car may be stopping or rolling because of a treadle on floor or pocket in floor • If the friction is too high-apply more soap or lubrication. • The faster the brush RPM, the more travel on the back of the vehicle-adjust RPM Mirror is damaged or broken Possible Causes & Troubleshooting: • Lower portion of the brush is set to high coming into contact with mirrorstay below 33” from the top of the lower fuller section of the brush. • Arm is restricted not to swing out far enough to clear the vehicle-adjust the bumper so that brush can clear the vehicle. • Too much tilt on the bearing causing excessive side pressure –adjust the tilt on the bearing to reduce the pressure. • Weak shocks absorbers-replace shock absorbers. • Brush speed incorrect-set the speed.

The Stainless Steel AVW - Z - Dual Wrap w/Dual Mini Mitter Combo and the best Mini Mitter combined in one unit ideal for space savings in tunnels and clean appearance desired in longer tunnels. Z-Wrap Around operate gravity. No complicated controls, because of the Design it can self adjust to most conveyor speed requirements. Simple design is constructed of heavy grade Stainless steel. Van High brush height is ideal for vans and sport utility vehicles because it cleans the sides with smooth even pressure.

• For Wrap Around: Displacement 12.05cu.in./rev., 18GPM, 60 RPM)
• Water: ½” NPT Outlet Equipment Center Line
• For Mini Mitter: 3.6GPM, 60RPM
• Water: 1/2’’NPT, 3GPM
• Hydraulic Motors
• For Contour Brushes: Displacement 5.0cu.in./rev. (= 1.3GPM at 60RPM, RPM is adjustable)